8
REMOVING THE DUST BAG:
Unlock the Velcro straps and then remove the dust tube from blower. Empty the bag into a
metal or non-flammable container away from your work area.
DO NOT LEAVE DUST
BAG
ON THE UNIT WHEN NOT IN USE
. Remove from machine when not in use for
two (2) minutes or more and store in a metal container away from flammable objects. DO
NOT TRANSPORT MACHINE WITH DUST BAG ATTACHED. Remove from unit, empty
and carry separately.
ADJUSTING THE HANDLE POSITION
Loosen the black knob (US146-146) and then adjust the handle position as
desired. Tight the black knob once adjusted.
PROPER STORAGE OF THE POWER SUPPLY CORD
Wrap the power cord around the frame of the machine for storage. Then,
adjust the handle to the lowest position and store machine in and upright
position.
CLEANING AND STORAGE
Remove the dust system from the unit. Discard contents away from work
area in a non-flammable area. Wipe the exterior of the unit with a damp
cloth. Leave the last grit of sandpaper on the backer pads for transport and
storage. This will protect the hook and loop of the backer pads.
US-146 Parts
U-SAND FLOOR SANDER
US-146 MODEL
PARTS LIST
November 2014
LS-AS LOWER SHAFT ASSEMBLY
A1
Lower Shaft (US104-146) (1)
A2
Bearings (HW-BRG) (2)
A3
Snap Ring (HW-ESR) (1)
SP-AS SPINDLE ASSEMBLY
LS-AS (1)
B1
Main Shaft (US103-146) (1)
B2
Spindle Housing (US101-146) (1)
B3
Bearings (HW-BRG) (2)
B4
Spindle Pulley (US106-146) (1)
B5
Upper Shaft Bearing Spacer (US105-146-7) (1)
