ZenCut Black User Manual
Installation
2-4
Step 6
Insert the roll holder support with the screws into the holes of the stand, then tighten them up
as shown in
Figure 2-6
. You can change decide roll holder support’s position by inserting into
different holes.
Step 7
Place two roll holders into the holes in the roll holder support (
Figure 2-7
)
Roll holder support
Roll holders
Figure 2-7
Step 8
The fully assembled plotter is shown below. (see
Figure 2-8
)
Figure 2-8
Summary of Contents for ZENCUT Black
Page 1: ...V1 June 09 User Manual...
