ZenCut Black User Manual
The Control Panel 3-3
3.3 Menu in Off-line Mode
Press [ON/OFF LINE] to switch to the offline mode
使用 选择
Quality: normal
Select: OK:ENTER
Square Cut
Select: OK:ENTER
[CUT TEST ]
Repeat Last Plot
Select: OK:ENTER
OverCut: 0.00mm
Select: OK:ENTER
Pouncing 0 mm
Select: OK:ENTER
Set Tangential Mode
Select: OK:ENTER
Panel Setup
Select: OK:ENTER
Restore default ?
Select: OK:ENTER
Save parameter ?
Select: OK:ENTER
Scale Width
Select: OK:ENTER
Scale Length
Select: OK:ENTER
Select Unit
Select: OK:ENTER
Select Language
Select: OK:ENTER
Set Communication
Select: OK:ENTER
Paper Saving Mode
Select: OK:ENTER
[
MISC
]
Both Expanded Mode
、
Length Expanded Mode
、
Width Expanded Mode
、
Both Unexpanded Mode
OverCut:0.00-1.00mm with an
increment of 0.05mm
Pouncing:0-200mm with an
increment of 1mm
English,Chinese
Metric (cm/gf) or English
measurement (inch/oz)
Auto Unrolled Media
Select: OK:ENTER
Media Back & Forth
Select: OK:ENTER
Vacuum
Select: OK:ENTER
Firmware
:
x.x.xx
FPGA
:
Vx.x mm/dd/yy
Set Smoothing Cut
Select: OK:ENTER
1S:72 F:80 O:0.275 M
Select: OK:ENTER
[TOOL SELECT
]
Draft, Fair, Normal, Fine, Small Letter
Speed: 72 cm/s
Select: OK:ENTER
Speed:3~153 with an increment of 3(cm/s)
UP Speed: 72 cm/s
Select: OK:ENTER
UP Speed
:3~153 with an increment of 3(cm/s)
[ SPEED ]
[
]
move origin
X: Y:
[ OFFSET ]
Offset: 0.275 mm
OK:ENTER
0.000~1.000 with an increment of 0.025(mm)
[ DATA CLEAR
]
Clear Data Memory
N:Cancel OK:ENTER
Force:80 gf
OK:ENTER
5~600 with an increment of 5(gram force)
[ FORCE]
Offline For
System Setup
Summary of Contents for ZENCUT Black
Page 1: ...V1 June 09 User Manual...