ZenCut Black User Manua
l
Step 3
Load the media on the platen. Please refer to “4.1.1 Loading the sheet media”. After loading
the roll media, flatten the media on the platen and hold the front edge of the roll media firmly
(Figure 4-9).
Figure 4-9
Figure 4-10
Step 4
Make sure that the media
tension is equally distributed
from left to right. If the media
is not taut enough against
the platen, it will cause
t r a c k i n g p r o b l e m s !
Note :
Turn the roll downward to equalize tension across the
media (Figure 4-10)
Step 5
Move the pinch rollers to the appropriate location and
note that the pinch rollers must be positioned above
the grid drums.
Step 6
Push the lever backward to lower down the pinch rollers.
Step 7
Fix roll media guide bushes on the roll holder to secure the roll media.
Step 8
Turn on the power switch. The tool carriage will size the media automatically. Now the cutting
plotter is ready to operate.
Step 9
Use the reverse steps to remove the media.
Operation
4-4
Summary of Contents for ZENCUT Black
Page 1: ...V1 June 09 User Manual...
