ZenCut Black User Manua
l
4.4
How to Cut 3mm Letters
To obtain good quality output, narrow media is recommended. However, if wide media is used,
you should:
1. Position two pinch rollers as close as possible to both edges of the cutting area.
2. Make sure the loaded media is held flat with equal tension across the platen.
3. Suggested
operation
settings:
Tool force: 55 gf. (or depending on the material)
Cutting speed: 45-50 cm/sec
Tool up speed: 45-60 cm/sec
Smooth cut: Disable
Quality: Small Letter
4.5
How to Make A Long Plot
When you are making a long plot with a roll of heavy and wide vinyl or paper, you need to use
the “AUTO UNROLL MEDIA“ function. The following parameter settings are to help users get
the best cutting quality. The actual output quality may vary when using different kind of
materials.
1. If the length of graphic is between 3m(9.84 ft) and 5m(16.4 ft), the
cutting speed is better at a speed lower than 72cm/sec, with the cutting
quality is set as Normal.
2. If the length is longer than 5m(16.4 ft), or if the material type is difficult
to cut, it is better to further slow down the cutting speed.
3. After loading the roll media, all pinch rollers should be raised at this
stage. Flatten the media on the platen and hold the front edge of the roll
media firmly (Figure 4-14).
Figure 4-14
Operation
4-7
Summary of Contents for ZENCUT Black
Page 1: ...V1 June 09 User Manual...
