ZenCut Black User Manual
Accu-Aligning System
5-8
■
When printing on roll media, make sure the orientation is as follows:
Step 4 Load the printout onto cutter
■
The Origin Mark is different from the rest of the registration marks. Please make sure
the media is fed in the right direction.
Step 5 Cut the Contour
■
Send the command from your software to perform the contour cutting job.
5.5
Tips
for
AAS
To get the best results in contour cutting, please follow these tips:
Keep light sources simple and avoid illuminating from the sides of cutter.
Before operating AAS, set the appropriate maximum paper size in ZenCut Black
driver property.
STEP 1
Find the
ZenCut Black model
in the “Printer & Fax” folder of your PC.
STEP 2
Open the Properties window and select the “Paper” tab.
STEP 3
Change the maximum Paper Size of X to
1200mm
(about 47”)
Adjust the cutting speed to between 300~600mm/sec. (11.8~23.6in/sec)
Avoid the registration marks located on the tracks of pinch rollers.
Summary of Contents for ZENCUT Black
Page 1: ...V1 June 09 User Manual...
