Cold Press Juicer 23
STEP 4:
• Remove the auger, from the juicing bowl.
• Next remove the filter assembly from the
juicing bowl.
• Separate the filter and the spinning brush
as shown below.
• Clean the components with water using
the cleaning brush provided with the
juicer
Note:
Immediately clean the juicer after
each use. If remaining residue in the juicer
dries up, it can make disassembling and
clean-up difficult. The excess build up may
cause poor performance in future uses.
• For easier disassembly, place the top-set
in the sink and run water through from
the top of the top-set.
• After cleaning ,thoroughly dry the
bottom of the auger where it connects
to the metal cylinder shaft on the base
1
2
3
