The OEM integrator is still responsible for
1.
ensuring that the end-user has no manual instructions to remove or install module.
2.
the ISED compliance requirement of the end product, which integrates this module.
3.
Appropriate measurements and if applicable additional equipment authorizations of the host
device to be addressed by the integrator/manufacturer.
4.
The separate approval is required for all other operating configurations, including portable
configurations and different antenna configurations.
This device is intended only for OEM integrators under the following conditions: (For module device use)
1) The antenna must be installed such that 20 cm is maintained between the antenna and users,
and
2) The transmitter module may not be co-located with any other transmitter or antenna.
As long as 2 conditions above are met, further transmitter test will not be required. However, the
OEM integrator is still responsible for testing their end-product for any additional compliance
requirements required with this module installed.
Information on test modes and additional testing requirements:
This module is restricted to integration into hosts for indoor use only.
This module has been approved under stand-alone configuration.
OEM integrator has be limited the operation channels in channel 1-11 for 2.4GHz band.
The separate approval is required for all other operating configurations, including portable configurations
with respect to Part 2.1093 and different antenna configurations
The information on how to configure test modes for host product evaluation for different operational
conditions for a stand-alone modular transmitter in a host, versus with multiple, simultaneously transmitting
modules or other transmitters in a host can be found at KDB Publication 996369 D04.
Cet appareil est conçu uniquement pour les intégrateurs OEM dans les conditions suivantes: (Pour
utilisation de dispositif module)
1) L'antenne doit être installée de telle sorte qu'une distance de 20 cm est respectée entre
l'antenne et les utilisateurs, et
2) Le module émetteur peut ne pas être coïmplanté avec un autre émetteur ou antenne.
Tant que les 2 conditions ci-dessus sont remplies, des essais supplémentaires sur l'émetteur ne
seront pas nécessaires. Toutefois, l'intégrateur OEM est toujours responsable des essais sur son
