Assembly Manual
Installation and Assembly Manual.
Step 1. Make sure that the package contains the following items:
1.
transparent PVC awning with “pockets” for the frame;
2.
a fiberglass frame set (7 or 9 pieces depending on the awning model)
3.
anchors with hinges
4.
six corkscrews (10 for LetoTent 650)
5.
six hooked pins
6.
tension rope - 1 piece
7.
self-tapping screws for securing the frame parts.
Step 2: Decide on the location of the LetoTent.
Decide where you want to install the LetoTent. Please keep the following in mind:
a) Choose a flat area, otherwise, the awning won’t close properly.
b) Determine the location of the awning opening, let's call it the front of the awning.
Thus, two anchors are on the sides of the structure, and you cannot enter or exit the
awning in these places. The awning can only be opened and closed in the front or
behind.
c) Make sure that there is at least 25 cm of passage around the awning. In the back
of the awning from the inside, there should be at least 40 cm of free space for folding
the awning since the awning folds inwards.
d) If possible, choose such place to open the awning, where there is the least
resistance to the headwind.
e) The length of the attached tension rope is the length required between two
anchors, this refers to the distance between the crossbars of the two anchors (on
which the hinges rotate).
