6
© 2021 United States Stove Company
ASSEMBLY & INSTALLATION
11. Attach stove piping (see instructions).
12. The stove must have its own flue. Do not connect this
unit to a chimney flue serving other appliances. This
stove has a circular flue outlet and uses a standard 6”
stovepipe. To attach pipe, simply slide the end of the
stove pipe into the flue outlet and secure with metal
screw.
CORRECT
WRONG
WRONG
Stovepipe/Flue Connections
CAUTION:
KEEP FURNISHINGS AND OTHER COMBUSTIBLE
MATERIALS AWAY FROM THE HEATER.
13. If your chimney continues to draft excessively, then
use a barometric draft regulator.
14. Use three (3) sheet metal screws in each stove
pipe and/or elbow joint to firmly hold the stove pipe
together. Use 6” round black/blue stove pipe, not
galvanized stove pipe .
15. Double check instructions 2 through 7 to be sure you
have the proper clearances shown from the stove and
the connector pipe to combustible surfaces. NOTE: If
a wall is only faced with brick or stone, consider it as
a combustible wall.
16. DO NOT install this stove in a mobile home or trailer.
17. If you have too much draft, then install a 6” cast iron
stove pipe damper in the first joint of the stove pipe.
MASONRY CHIMNEY
The masonry chimney must comply with UL codes. Before
using an existing masonry chimney, clean the chimney
and inspect the flue liner to be sure it is safe to use.
Make repairs before attaching the heater. The connector
pipe and fittings you will need to connect directly to
a masonry chimney are shown. If the connector pipe
must go through a combustible wall before entering the
masonry chimney, consult a qualified mason or chimney
dealer. The installation must conform to local fire codes,
and NFPA 211. Do not connect this heater into the same
chimney flue as the fireplace or flue from another heater.
The chimney used for a heater must not be used to
ventilate the cellar or basement. If there is a cleanout
opening at the base of the chimney, close it tightly.
LISTED CHIMNEY
Carefully follow chimney manufacturer's instructions.
Use only 6" black or blued chimney connector, minimum
24 gauge steel and UL 103 HT factory built chimney,
utilizing manufacturers instructions. If your chimney
starts at the ceiling, you will need enough 6” pipe to reach
the ceiling. The top of the chimney must be at least 3 feet
above the roof and be at least 2 feet higher than any point
of the roof within 10 feet.
FLOOR
PROTECTOR
PIPE
ELBOW
PIPE
COLLAR
THIMBLE
BAROMETRIC
DRAFT
REGULATOR
NON-COMBUSTIBLE WALL
FLUE CONNECTION
NON-COMBUSTIBLE WALL
FLUE CONNECTION
NON-COMBUSTIBLE WALL
