4 / 50
P/N 466-2938-ML
• REV A • ISS 29JAN19
signal strength of a
wireless sensor’s last event transmission
on the RAS screen.
The RSSI indicator shows signal level for the selected zone as
a bar indicator. 5 bar level (IIIII) means the best possible
signal, 0 bar level is the worst one.
The approximate connection quality levels are listed in Table 2
below.
Table 2: RSSI values
Value
(dBm)
Screen bar
indicator
Received signal
<−99
[...........]
Signal is insufficient. The sensor does not
work.
Move the receiver or use a repeater.
−98 to −85 [.I.........]
Weak signal. The senor may work, but the
operation is not recommended, because the
wireless device will cause RF supervisory
faults.
−84 to −69 [.I.I.......]
Medium signal. The sensor works, although
supervision for this RF device may have to
be switched off.
−68 to −53 [.I.I.I.....]
Good signal.
−52 to −37 [.I.I.I.I...]
Strong signal
>−37
[.I.I.I.I.I.]
Excellent signal.
Note:
For a reliable communication it is strongly recommended
to maintain minimum 2 bar signal level, which is equal to the
value between −84 and −69 dBm.
Specifications
Compatibility
433 MHz Learn Mode wireless
sensors.
Advisor Advanced firmware version
MR4.2 or later.
Supported protocols
Legacy 433 MHz (63 bit)
LoNa (80+)
Wireless zones
32 per DGP (programmable)
Wireless operating frequency
433.05 to 434.79 MHz
Fobs
16
Power required
9.5 to 14.4 V
±2%, 70 mA ±10%
Maximum recommended bus
distance
1500 m using WCAT52/54, two
twisted pairs, shielded data cable.
Relay rating
30 VAC at 1A, or 30 VDC at 1 A
Operating temperature
−10 to +55°C
Maximum relative humidity
95% noncondensing
Dimensions (L x W x H)
16.5 x 11.5 x 4 cm
Weight
350 g
Regulatory information
Manufacturer
PLACED ON THE MARKET BY:
UTC Fire & Security Americas Corporation, Inc.
3211 Progress Drive, Lincolnton, NC, 28092, USA
AUTHORIZED EU REPRESENTATIVE:
UTC Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, Netherlands
Product warnings
and disclaimers
THESE PRODUCTS ARE INTENDED FOR SALE
TO AND INSTALLATION BY QUALIFIED
PROFESSIONALS. UTC FIRE & SECURITY
CANNOT PROVIDE ANY ASSURANCE THAT
ANY PERSON OR ENTITY BUYING ITS
PRODUCTS, INCLUDING ANY “AUTHORIZED
DEALER” OR “AUTHORIZED RESELLER”, IS
PROPERLY TRAINED OR EXPERIENCED TO
CORRECTLY INSTALL FIRE AND SECURITY
RELATED PRODUCTS.
For more information on warranty disclaimers and
product safety information, please check
https://firesecurityproducts.com/policy/product-
warning/
or scan the QR code.
Certification
UTC Fire & Security hereby declares that this
device is in compliance with the applicable
requirements and provisions of all applicable rules
and regulations, including but not limited to the
Directive 2014/53/EU. For more information see:
www.utcfssecurityproducts.eu
2012/19/EU (WEEE directive): Products marked
with this symbol cannot be disposed of as
unsorted municipal waste in the European Union.
For proper recycling, return this product to your
local supplier upon the purchase of equivalent
new equipment, or dispose of it at designated
collection points. For more information see:
www.utcfssecurityproducts.eu/recycle/
Contact information
www.utcfireandsecurity.com or www.interlogix.com
For customer support, see www.utcfssecurityproducts.eu
CS
: Instalační příručka
Úvod
Expandér ATS1236 Advanced Wireless DGP rozšiřuje vstupy
ústředny ATS o 433MHz bezdrátové senzory. Expandér
ATS1236 podporuje starší 63bitové senzory i senzor 433MHz
senzory LoNa.
Expandér ATS1236 podporuje maximálně 32 senzorů
a 16
přívěsků.
Ke každé datové sběrnici ústředny lze připojit až 15 expandérů
ATS1236 DGP.
Expandéry ATS1236 mohou mít připojeny až 2 kabelové zóny.
Expandér ATS1236 má jeden reléový výstup CO.
Když je připojen jeden nebo více bezdrátových expandérů
ATS1236,
maximální doporučená délka datové sběrnice je
1500 m.
Bezdrátový expandér může být napájen z datové sběrnice
ústředny ATS nebo ze vzdáleného pomocného zdroje
napájení.
Tlačítka přívěsku lze naprogramovat, aby zapínala či vypínala
oblasti nebo ovládala relé. Relé lze například používat
k
dálkovému otevírání a zavírání dveří garáže.
