Chapter 3: Configuration and commissioning
42
ZP1-X3E Series Installation Manual
Safety door monitoring
Use this menu to configure safety door monitoring, on or off. The default setting
is OF.
For a description of the safety door monitoring function, see “Connecting a safety
door fault monitoring device” on page 13.
To configure safety door monitoring:
1. Set the display as shown below, and then press Enter.
The Door Fault LED flashes fast to indicate that the configuration menu is
active.
2. Select a value using the value selection buttons (2 and 4).
3. Press Enter.
4. Save your changes.
The available settings for this feature are shown below.
Display
Description
Safety door monitoring is used (on).
Safety door monitoring is not used (off).
Safety door fault delay
Use this menu to configure a delay from 10 to 90 seconds (in steps of 5 seconds)
in reporting safety door faults caused by incorrect status (open or closed). The
default setting is 30 seconds.
To configure a safety door delay:
1. Set the display as shown below, and then press Enter.
The Door Fault/Disabled LED flashes fast to indicate that the delay
configuration menu is active.
2. Select a delay value from 10 to 90 seconds using the value selection buttons
(2 and 4).
3. Press Enter.
4. Save your changes.
