11921015 Rev A
8
© 2013 UTC RETAIL.
All rights reserved.
Figure 4, HDD seen under the
opened door
Connect Power Cable
Place the 2170 POS face down on a clean, soft surface, ensuring you do not scratch the front
bezel or the touchscreen.
Plug the supplied AC cord into the power adapter mounted into the base. See photo below.
Stand the system on its feet and snake the power cable through the cutout in the rear of the
base.
Figure 3, AC Power Cord Attachment
Expansion Options
None, the system does not accept any internal expansion cards.
Hard Drive Removal
The 2170 POS System is equipped with one easily accessible hard drives.
To remove a hard drive, follow these steps:
1. Shut off all power to the system, unplug the
power cord from the AC outlet.
2. Remove the single screws on the rear panel
and lift off the hard drive access cover.
3. Disconnect the HDD cabling.
4. Replace hard drive.
5. Reconnect the cabling and install the door.
