Pg. 15
BLL-95CU-PS
ADVANCE TRIGGER AND RELEASE BUTTON
1. The ram moves forward when the trigger is pressed and stops when the trigger is released.
2. To retract the ram, push the release button. The ram continues to retract as the release button
is held down.
CUTTING
1. Retract the cutting head jaws fully by pressing the release button.
2. Place the wire between the cutting head jaws. Make sure all cuts
are made perpendicular to the cutting head.
3. Press the advance trigger to start the cutting cycle.
4. Once cutting cycle is complete, the cutting head jaws will release back to their open position
NOTE: There is no need to advance tool to bypass. Once cut is complete, release the
trigger. This will save battery life, time, and the overall life of the tool.
5. You can back the ram up at any time during the cutting cycle, even without the battery.
NOTE: If advance trigger is held down after cut is made, the tool will continue to max
pressure.
2
MAX.
1
CAUTION: always wear eye protection
while cutting
WARNING:
do not cut steel.
Summary of Contents for UtilPro BLL-95CU-PS
Page 20: ...Pg 20 BLL 95CU PS Notes Notes ...
Page 21: ...Pg 21 BLL 95CU PS Notes ...
Page 22: ...Pg 22 BLL 95CU PS Notes ...
Page 23: ...Pg 23 BLL 95CU PS Notes ...
