2
2
11)
11)
DO NOT carry the load unpackaged. Be careful when carrying large loads.
DO NOT carry the load unpackaged. Be careful when carrying large loads.
12)
12)
T
Take care not to lose load
ake care not to lose load when the lift height is
when the lift height is greater than 3 m
greater than 3 meters.
eters.
13)
13)
Travel with load as low as possible and
Travel with load as low as possible and tilt back the mast.
tilt back the mast.
14)
14)
Before driving over a dock
Before driving over a dock
--
board or bridge
board or bridge
--
plate, be sure that it is properly secured and strong enough to sustain
plate, be sure that it is properly secured and strong enough to sustain
the total weight of the truck and load.
the total weight of the truck and load.
15)
15)
Make sure that there is
Make sure that there is no open flame near the area.
no open flame near the area. Never smoke near the area. The driver must not
Never smoke near the area. The driver must not remain
remain
seated while adding fuel. USE a sealant on all LPG connections having NPT threads.
seated while adding fuel. USE a sealant on all LPG connections having NPT threads.
16)
16)
Treat the truck with attachments as a loaded truck.
Treat the truck with attachments as a loaded truck.
17)
17)
When leaving the truck, you should put the forks down, make the shift lever is in neutral, shut down the engine
When leaving the truck, you should put the forks down, make the shift lever is in neutral, shut down the engine
and cut the power. When parking on a grade, make sure to tighten the brake lever. If necessary, use a block
and cut the power. When parking on a grade, make sure to tighten the brake lever. If necessary, use a block
when parking on a grade for a long time.
when parking on a grade for a long time.
18)
18)
If the truck suddenly malfunctions, or for leakage of electrolyte, hydraulic oil or brake oil, when lifting goods or
If the truck suddenly malfunctions, or for leakage of electrolyte, hydraulic oil or brake oil, when lifting goods or
grade climbing, leave truck in safe state and contact service technician immediately.
grade climbing, leave truck in safe state and contact service technician immediately.
19)
19)
During installation and assembly, there will be noise and vibration. Please choose the right tool and assembly
During installation and assembly, there will be noise and vibration. Please choose the right tool and assembly
method. Minimize the noise and vibration as soon as possible to reduce noise pollution.
method. Minimize the noise and vibration as soon as possible to reduce noise pollution.
20)
20)
The work road surface for forklift should be stable and free of litter, preferably cement, blacktop or concrete. If
The work road surface for forklift should be stable and free of litter, preferably cement, blacktop or concrete. If
there is snow, ice, water or other eye irritants,
there is snow, ice, water or other eye irritants, protect against these and resum
protect against these and resume work.
e work.
https://www.forkliftpdfmanuals.com/
Summary of Contents for UT25C
Page 85: ...79 79 10 Labels 10 Labels https www forkliftpdfmanuals com ...
Page 90: ...84 84 7 7 Tip Over Warning Label Tip Over Warning Label https www forkliftpdfmanuals com ...
Page 119: ...113 113 https www forkliftpdfmanuals com ...
Page 139: ...133 133 IMPCO Single Fuel System IMPCO Single Fuel System https www forkliftpdfmanuals com ...
