11
Aeromaster on Ford Chassis—Body Wiring Manual
Illustration BA–15
Negative (Black) Cable Disconnected and Tucked Away
Illustration BA–10
Plugging in a Memory Saver
Illustration BA–5
Battery Under the Hood and Optional Locking Strut
Disconnection
1. Make sure the ignition switch is Off.
2. You
may
need to plug a memory saver
(with 9-volt battery) into the accessory
outlet on the dash. (See Illustration BA–
20.)
Check your chassis-supplied
operation or service information for
specific recommendations.
3. Disconnect the
Negative (Black)
battery
cable(s)
first
. (See Illustration BA–25.)
4. Tuck the battery cable away from the
terminal to prevent accidental contact.
5. When servicing the vehicle is finished,
reconnect the cable.
Removal
1. Disconnect battery. (See the
Disconnection Section.)
2. Remove the Positive battery cable(s).
3. Remove the battery hold-downs.
4. Note the location of the posts and remove
the battery from the vehicle.
Installation
1. Install the battery in the battery tray—
in
the same orientation
.
2. Secure the battery hold-downs.
3. Connect the battery cables, Negative last.
NOTE: Remember to fasten the
hood or access panel.
Summary of Contents for Aeromaster 1997
Page 55: ......
