Fig. 5
Fig. 6
See installation steps 5 & 6
WARNING:
Your Metal Halide Security Light is designed to operate safely with
ONLY
a 100-watt
metal halide type M90/E bulb.
Replace with only a 100-watt Metal Halide type M90/E bulb.
Installation
of any other bulb type may cause damage to the fixture.
8
DANGER:
Turn power off at the circuit breaker or fuse box before
replacing bulb.
DANGER:
DO NOT rely on wall switch alone to turn off power.
ON
ON
ON
OFF
ON
ON
ON
ON
OFF
INSTALLATION INSTRUCTIONS
continued
For optimal performance the arrow on the photocontrol (B) should be facing north after (A) is installed.
If adjustment is needed, loosen the screw in the center of the white photocontrol receptacle (AB) two
turns. Rotate (AB) so that the arrow will point north when installed and retighten screw. Note: There is
a stop to prevent (AB) from turning all the way around. If you have trouble turning (AB), try turning it in
the other direction.
Install (B) by aligning the arrow on top of (B) with arrow on (AB). Push down and twist clockwise.
CAUTION:
(B) will only plug in one way. Align the large prong on (B) with the large opening in (AB).
NO R TH
BULB REPLACEMENT
Step 7:
Install Photocell
SC
To test operation during the daytime, cover (B). Turn the power on. Light should turn on and reach
full brightness within 10 minutes. Expose (B) to daylight. Light should turn off within two minutes.
With (B) exposed, the light will operate automatically: ON at dusk and OFF at dawn.
A
A
B
(Top View)
AB
Lowes.com
