NuvaWave Handheld Disinfection Device Instructions for Use
037-0110 (Rev C)
© 2020 UV Innovators, LLC
Page 23 of 35
The belt buckle should be centered on your waist. To attach the battery to the belt, remove the battery
from the storage case. Insert the battery into the battery mount
on the belt until it “clicks” in place.
Figure 3.2.2
–
Belt with Battery pack installed
To insert NuvaWave into your device holster, first put on the belt and ensure it has been adjusted to fit
comfortably over your PPE. The holster will be pre-attached but can be moved to the right or left side
of the belt for comfortable access. Rotate NuvaWave so that the UVC Light Source is pointing
towards the ground, and the UVC Light Source is pointed away from your body. Line up the handle of
the device with the opening in the holster. Push the handle back into the holster and slide the device
down until NuvaWave is firmly in the holster. The power cable should be coming up from the bottom of
the device and should be clearly visible from the belt.
3.2.3
Connecting the Battery to NuvaWave
Ensure the power switch located at the bottom of NuvaWave is in the OFF position.
Remove NuvaWave from the holster and insert the battery cable into the connector on the bottom of
the device, pushing in and twisting clockwise simultaneously to secure the connection. To check the
battery charge level, press the battery charge indicator button located here:
Figure 3.2.3: Charge Indicator Button on Battery
Battery charge
indicator button
