i. When the preferred transmission protocol shows on
display, press
TARE
to confirm and proceed to the
next selection or
ZERO
to restart the scale
NOTE:
The default data output format of the scale is
Baud Rate = 9600
Data Bit = 8
Stop Bit = 1
Parity = None
4.2.4 Select Digital Motion Filtering Function
This indicator equipped with animal weighing function
that enables user to select when the indicator is using
for weighing livestock.
a. Scale is off
b. Press and hold
TARE
, then press
ON/OFF
c. Indicator displays
F.1
d. Press
TARE
five times to
F.6
e. Press
MODE
to shift between Filt.0 or Filt.1
-
To enable
Animal Weighing Function
, press
TARE
when display shows
Filt.1
-
To disable
Animal Weighing Function
, press
TARE
when display shows
Filt.0
f. After
TARE
is pressed, indicator display
F.7
g. Press
MODE
to enter next set up or
ZERO
to restart
the scale
4.2.5 Select Serial Output Mode
There are two selectable transmission formats to choose
according to end user preference. For which FORMAT 1
is continuous transmission when weight is stabilized
and FORMAT 2 sends data in table form when press
M+
.
a. Scale is off
b. Press and hold
TARE
, then press
ON/OFF
c. Scale displays
F.1
d. Press
TARE
six times to
F.7
e. Press
MODE
to shift between Ser.0 or Ser.1
-
For continuous sending, press
TARE
when display
shows
Ser. 1
-
For manual sending, press
TARE
when display shows
Ser. 2
f. After
TARE
is pressed, indicator display
F.8
g. Press
MODE
to enter next set up or
ZERO
to restart
the scale