5.4 TURN BACKLIGHT (OPTIONAL) ON/OFF
Follow the below steps to turn on and off backlight (if
purchased).
a. Scale is on
b. Press and hold
ZERO
until backlight is activated;
or press
MODE
to shift between metric and avoirdupois
weight to turn on and off backlight
When backlight function is employed, it will
automatically turn off when a stable weight remains for
25 seconds or a zero weight is detected and remains stable
for 10 seconds. Backlight will be automatically turned
on again when a new weight is detected or when any key
is pressed.
5.5 SET DISPLAYED VALUE TO ZERO WHEN UNLOADED
By pressing
ZERO,
weight displayed will be set to zero
and
ZERO INDICATOR
appears.
Refer to
SPECIFICATIONS
for maximum zero range.
NOTE:
-When the operating environment is unstable, scale
memorizes the command and will take place when
environment is stable
5.6 TARE OFF THE WEIGHT OF A CONTAINER
When a container is used, follow the steps below to
manually tare off the weight of container and get the
net weight.
a. Remove all loads away from platter
b. Make sure that the
ZERO INDICATOR
is on.
c. Place the container on the platter.
d. Press
TARE
.
After
TARE
is pressed, the
NET INDICATOR
will appear.
Refer to
5.2
for weighing procedures. Weight displayed
under is the net weight of the subject matter. Refer
to
SPECIFICATIONS
for maximum tare range.
NOTE:
-When the operating environment is unstable, scale
memorizes the command and will complete the command when
the environment is stable
5.7 CLEAR THE TARE FUNCTION
a. Remove all loads from platter
b. The tare effect will be cancelled:
-Automatically if automatic tare function is
