c. Scale displays zero weight; if not, press
ON/ZERO
.
d. Press and hold
ON/ZERO
. Scale displays:
-L._oFF
= Function enable
-L1._on =
Function disable.
5.5 SET DISPLAYED VALUE TO ZERO WHEN UNLOADED
Press
ON/ZERO
can eliminate a positive or negative value
when scale is not at its zero. After
ON/ZERO
is pressed,
the
ZERO INDICATOR
appears.
Refer to
SPECIFICATIONS
for maximum zero range.
5.6 TARE OFF THE WEIGHT OF A CONTAINER
When a container is used, follow the below steps to
manually tare off the weight of container and get the
net weight.
a. Remove all loads away from platter
b. Make sure that the
ZERO INDICATOR
is on.
c. Place the container on the platter.
d. Press
TARE
.
After
TARE
is pressed, the
NET INDICATOR
would appear.
Refer to
5.2
for weighing procedures. Weight displayed
under is the net weight of the subject matter. Refer
to
SPECIFICATIONS
for maximum tare range.
5.7 CLEAR THE TARE FUNCTION
a. Remove all loads from platter
b. The tare effect will be cancelled:
-Automatically if Auto Tare Function is employed,
or
-By pressing
TARE
c. After
TARE
is pressed, the
NET INDICATOR
would
disappear.
5.8 WEIGHT CHECK FUNCTION
This scale is equipped with Weight Check Function. An
audio and video signal is generated to reflect the weight
check result.
5.8.1 Setting the High, Low Weight Limits and Buzzer
Warning
a. Remove all loads from platter.
b. Turn scale on.
c. Make sure that
ZERO INDICATOR
is on; if not, press
ON/ZERO.
d. Press and hold
ON/ZERO
, then press
TARE.
e. The
HI INDICATOR
appears and the cursor is flashing,
