Installation Instructions, Viper 2000 Control System
UWE Verken AB
Box 262
S-601 04 Norrköping, Sweden
Phone +46 11 24 88 00
Fax +46 11 12 47 04
www.uwe.se
4.
The feedback potentiometers can be connected
directly between GND and +24V. Variations of
supply voltage is internally compensated.
5.
Direct drive capability is a hardware option that
can be delivered on request. Since no single input
pin can carry a load of more than 10A, additional
Batt+ connections has to be done.
6.
If no high current drivers are used, only one of
these outputs need to be used. If only one high
curren driver is used, two of these has to be
connected and if two or more are used all three
supply pins should be connected.
A M P C o n n e c t i o n s
For information concerning contact housing, please see
product information PRD0166.
