Assembly
2
Complete the fitting as shown and if necessary, close the open section of the metal bracket
slightly with a pair of pliers as this will help to retain the cables. Connect the lower part of the
Exercise Monitor Link Wire (41) to the Exercise Monitor Sensor Wire (42), ensuring a tight connection.
Carefully lower the Handlebar Upright (73) onto the Main Frame (33), then loosely fit the
Upper holes by 3 x M8 x 20mm Allen Bolts (46), 3 x M8 Spring Washers (26) and 3 x M8
Curved Washers ( 27) as shown below. Fit 2 x M8 x 60mm Allen Bolts (45), 2 x M8 Curved
Washers (27) and 2 x M8 Curved Washers (27), 2 x M8 Locknuts (37) through the lower
holes on the Upright as shown below.
Note
Do NOT tighten the Handlebar
Upright at this stage.
A-1.Hold the Tension Cable (44) below the metal bracket. Guide the lower part of the
into the formed metal loop on the
A-2.Still holding the Tension Cable (44), pull the Tension Control Knob INNER Cable (74)
A-3/A-4. Slowly release the tension on the UPPER Cable and guide it carefully into the
hole in the top of the Metal Bracket.
INNER Cable of the Tension Control Knob (74)
INNER Cable of the Tension Cable.
away from the Metal Bracket (you will notice some resistance at this stage) and
guide the INNER Cable through the open slot in the Metal Bracket.
The Tension Control Knob (74)
must be set at position "1".
A-1
A-2
A-3
A-4
44
43
41
42
Page
1
8
Summary of Contents for AL16/1E
Page 2: ......
Page 22: ...Assembly Page 22...
