7
Assembly
Remove the 4 x M5 x 12mm Screws (21) from the back of the Exercise Monitor (1).
Connect the Upper Control Wire (29) and Pulse Wires (45) with wires from the
Exercise Monitor (1) matching like for like. Attach the Exercise Monitor (1) to the
Handlebar Upright (2) using the 4 x M5 x 12mm Screws (21) that were removed.
8
Remove the 3 x M8 Nylon Nuts (42) and 3 x M8 Flat Washers (20) from the
underside of the Saddle (13). Attach the Saddle (13) to the Saddle Stem Support
(10) using the 3 x M8 Flat Washers (20) and 3 x M8 Nylon Nuts (42) that were
removed. Fit the Saddle Stem Support (10) to the Saddle Post (11) using 1 x M8
Flat Washer (20) and 1 x Saddle Adjustment Knob (16).
Unscrew the Saddle Height Adjustment Knob (15) from Main Frame (7), then insert
the Saddle Post (11) to the Main Frame (7). Adjust the Saddle to the desired height
allowing for a slight knee bend at the bottom of the pedal action. Tighten the Saddle
Height Adjustment Knob (15) after adjustment.
Note
Set the saddle at an appropriate
height allowing for a slight
bend in the knee when the
pedal is at its lowest position.
FULLY TIGHTEN all Bolts,
Nuts and Fittings now, ensuring
that your ensuring that your
product in located on a clear flat
surface before doing so.
Your product will now be ready
to use.
Note
29
1
1
2
21
29
45
13
10
20
42
11
7
20
16
15
Page
Summary of Contents for PMCE-1
Page 2: ......
Page 19: ...Assembly Page ...
