6
Assembly
Connect the Pulse Wires (26 & 27) and Control Wires (28 & 29). Take care not to trap
any wires Carefully lower the Handlebar Upright (2) onto the Main Frame (7), then loosely
fit the 4 x M8 x 20mm Allen Bolts (18), 4 x M8 Spring Washers (17) and 4 x M8 Curved
Washers (19) at the edges and 2x M8 x 20mm Allen Bolts (18), 2 x M8 Spring Washers
(17) and 2 x M8 Flat Washers (15) on each side.
27
26
29
28
7
Remove the 4 x M5 x 12mm Screws (16) from the Exercise Monitor (1). Connect the
Pulse Wire (27) and Control Wire (29) to the wires from the back of the Exercise
Monitor (1a/1b), matching like for like. Attach the Exercise Monitor (1) to the Handlebar
Upright (2) using 4 x M5 x 12mm Screws (16) that were previously removed. Feed any
excess wire back down the Upright taken care no to trap any wires.
1b
1b
29
1a
1a
27
FULLY TIGHTEN all Bolts,
Nuts and Fittings now, ensuring
that your ensuring that your
product in located on a clear flat
surface before doing so.
Your product will now be ready
to use.
Note
Õº8
Page 1
7
Summary of Contents for PMRC-1
Page 18: ...Assembly Page 18...
Page 19: ...Assembly 42 40 Page 19...