Version 09.02.2012
VL2-MBN45
P
a
g
e
4
Requirements
Vehicle
Vehicles generation NTG4.5-204
Head-unit/monitor
Comand Online, Audio50 APS or Audio20 with 4pin HSD LVDS
connector on the monitor
Limitations
Video only
The interface inserts ONLY video signals into the infotainment.
For sound use the possibly existing factory-audio-AUX-input or a
FM-modulator.
1.2.
Checking the compatibility of vehicle and accessories
1.3.
Dip-switch settings
With the video interface boxes dip-switches it is possible to select vehicle/navigation the
interface is to be installed in (dip 7 and 8), to select the video signal of an optional connected
after-market navigation (Dip 4), to dis- or enable the interfaces inputs
(dip 1 to 3) and to preselect the type of camera which is (to be) installed
(dip 5).
Dip position down is ON and position up is OFF.
1.3.1.
Vehicle selection (dip 7-8)
Choose the vehicle/navigation/monitor the interface is to be installed to and set dip 7
through 8 according to the below table.
Vehicle/ Navigation
Dip 7
Dip 8
7“-monitor with resolution 800x480
OFF
OFF
5.8”- monitor with resolution 480x240
OFF
ON
5“- monitor with resolution 280x100
ON
OFF
1.3.2.
Video signal selection after-market navigation(Dip 4)
To the video interface’s RGB-input it is possible to connect a RGB- or a VGA-video source. Set
dip 4 according to table. Recommended resolution for VGA is 800x600 @ 60Hz.
After-Market Navigation
Dip 4
VGA (RGB-Input Pin 4 H-Sync, Pin 8 V-Sync)
ON
RGB NTSC
OFF
Note
: VGA-mode is only possible on the 7“-monitor.
