REV. F
CHAP. 8
PAG.
31/32
8 HOW TO TAKE THE COUPLING OUT OF SERVICE
Remove the nut cover (1), split pin (2) and the castellated nut (3);
Remove the rear flange (4) and the rubber buffer (8a);
This chapter refers to the figure on page 21/32.
Remove the tie rod (9) from the coupling flange (7a), remove the
front flange (5b) and the rubber buffer (8b);
1)
2)
3)
4)
5)
Remove the bolts (24) and the coupling flange (7a);
Lubricate the metallic parts with a thin layer of oil and keep the
coupling in a case strong enough.
For drawbar couplings E503, E504 and E505 remove also the
second rear flange (5a).
For drawbar couplings E506 and E509 remove the
reinforcement plate (7b).
N
O
T
E
DRAWBAR COUPLING E 50
INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
