temperature.
This device falls under protection-class I. Therefore it is essential that the
device be earthed.
The electric connection must carry out by qualified person.
The device shall only be used with rate voltage and frequency.
Make sure that the available voltage is not higher than stated at the end of this
manual.
Make sure the power cord is never crimped or damaged by sharp edges. If this
would be the case, replacement of the cable must be done by an authorized
dealer.
Always disconnect from the mains, when the device is not in use or before
cleaning it. Only handle the power cord by the plug. Never pull out the plug by
tugging the power cord.
During initial start-up some smoke or smell may arise. This is a normal process
and does not necessarily mean that the device is defective, it should decrease
gradually.
Please don't project the beam onto combustible substances.
Fixtures cannot be installed on combustible substances, keep more than 50cm
distance with wall for smooth air flow, so there should be no shelter for fans
and ventilation for heat radiation.
If the external flexible cable or cord of this luminaire is damaged, it shall
be exclusively replaced by the manufacturer or his service agent or a similar
qualified person in order to avoid a hazard.
2. 安全说明
该设备已经完好出厂。为了维持这种状态并确保安全操作，用户绝对有
必要遵守本用户手册中编写的安全说明和警告说明。
如果设备因环境变化而遭受温度变化，请勿立即开启设备。产生的冷凝
水可能会损坏设备。保持设备关闭，直到达到室温。 该设备属于
I
级
保护。因此，必须将设备接地。 电气连接必须由合格人员进行。 该设
备只能在额定电压和频率下使用。 确保可用电压不高于本手册末尾所
述的电压。 确保电源线不会被尖锐的边缘压接或损坏。在这种情况下，
必须由授权经销商更换电缆。 不使用设备时或清洁设备之前，请务必
断开电源
。只能通过拔插来处理电源线。切勿通过拉扯电源线来拔
Summary of Contents for BWZ3715
Page 10: ...ABS XY 10000 2500K 36 48 1 6 RGBW 7 Dimensions...
Page 28: ......
