TLT-2K Quick start Guide V3.0
12/19
MODE;
2. In this mode, if ACC is on, the device will be in normal mode; if ACC is off, it will enter into OFF mode; at
the timed expected moment, the device will be woken up automatically and after sending data, it will quit from
OFF mode.
3. In OFF mode, if the device vibrates, will quit from OFF mode immediately.
Note: in the two modes above, the device in OFF mode will be woken up
1. by power failure alarm;
2. by device vibration;
3. by SOS; or
4. at the timed expected moment specified by 819 instruction.
12.
12.
12.
12. Upload
Upload
Upload
Upload interval
interval
interval
interval setting
setting
setting
setting in
in
in
in OFF
OFF
OFF
OFF mode
mode
mode
mode
Format: #819#password#sampling interval##
For example: 8190000
Description: 1. The terminal receives this instruction, and then return confirmation information: “GPRS
REPORT SAMPLING 2 OK”;
2. Sampling interval ranges
【
10,2000
】
with unit: Minute;
3. After success to set the instruction, the device in OFF mode will start as per the set interval and then sends
information. The device will enter into OFF mode after completing sending message.
4. It should be noted that sampling interval being zero means not entering OFF mode; the respond information
is:
“
“
“
“SUPER
SUPER
SUPER
SUPER POWER-SAVE
POWER-SAVE
POWER-SAVE
POWER-SAVE MODE
MODE
MODE
MODE DISABLED
DISABLED
DISABLED
DISABLED”
”
”
”....
13.
13.
13.
13. Set
Set
Set
Set geo-fence
geo-fence
geo-fence
geo-fence
Format:006+user pGX,IO/I/O,E/W longitude upper limit+N/S latitude upper limit, E/W longitude
lower limit +N/S latitude lower limit
For example: 0060000G1,IO,E114.10004N22.55705,E115.10006N23.55706
Description: 1. The terminal receives this instruction and return confirmation information
：
“SET SQUARE
GEO-FENCE GX IO OK”
；
2. GX represents geo-fence X with the range
【
1
，
16
】
. Longitude and latitude are measured by the unit
“degree” and accounted to 5 decimal places;
3. The fence will be automatically started after setting is finished;
4. If calling status is OFF, it will only send message to prestored number user instead of calling him.
5. Longitude and latitude after restoration are represented by zero. Fence is in OFF status.
14.
14.
14.
14. Geo-fence
Geo-fence
Geo-fence
Geo-fence switch
switch
switch
switch
Geo-fence start format:311+pGX
For example: 3110000G1
Geo-fence closing format:310+pGX
For example: 3100000G1
Description: once the terminal receives geo-fence start (closing) instruction, it will return such information as
“SET SQUARE GEO FENCE GX:ON(OFF)”.
All manuals and user guides at all-guides.com
