V-Tec DT607C Series, User Manual

-5-

• 

If setting mode has not been exited, you can change the calling mode by pressing KEY1 circularly.

• 

The 

LED_NAME

 indicator will blink all the time until exit out the setting mode.

• 

If without any operation in 10 seconds, it will exit out setting mode automatically.

• 

In this step,press 

KEY_SET

 button three times to exit out the setting mode manually.

SETUP INSTRUCTIONS

* More details about code setting for monitor, please refer to corresponding user manual .

Each call button will respond different addresses when set in different calling mode. Refer to the 
followings for more informations.

Call buttonA:

 call the monitor with address 

01

 by default.

Call buttonB:

 call the monitor with address 

02

 by default.

Call buttonC:

 call the monitor with address 

03

 by default.

Call buttonD:

 call the monitor with address 

04

 by default.

Call buttonA:

 Call all monitors in group address from 

00~15.(one of the monitor should be set to 

00

)

Call buttonB,C,D:

 Call all monitors in group address from 

16~31. (one of the monitor should be set to 

16

)

UNLOCK Indicator:OFF
TALK Indicator:ON

Buzzer

Beep+, Beep

In standby mode, press 

KEY_SET

 button twice.

UNLOCK Indicator:OFF
TALK Indicator:ON

Buzzer

Beep+

Press 

KEY_1 

button to 

activate 

Standard calling

mode for door station.

UNLOCK Indicator:OFF
TALK Indicator:ON

Buzzer

Beep, Beep

Press 

KEY_1 

button again 

to activate 

Group calling

mode for door station.

Press 

KEY_1

A

B

C

A

B

C

D

A

A

B

1.Standard calling mode(Address range 01-04 
by default)

2.Group calling mode

To change this setting, please follow the steps: