6174007.fm
Extended Software Option
Chapter 2: Controller
23
These choices allow the user to toggle each of
the listed the sensors installed on the machine
to ON and OFF. An asterisk indicates the
option is turned ON. If the sensors listed are
not present on the machine, do not enable
them in this software screen.
EPD
EPD is the empty pocket detection system. It
is self initializing if turned ON. It will not cause
a fault signal until after the first part is seen, or
300mm of carrier tape has passed under it.
Track Jam
The track jam sensor watches for parts that
are riding on top of the carrier tape or other-
wise not in their pockets properly
Low Cover
The low cover sensor monitors the quantity of
cover tape that remains on the reel. It will fault
if it becomes too low.
Carrier Motion
The carrier motion sensor monitors the move-
ment of the carrier tape to assure it is moving.
Low Carrier
The low carrier sensor monitors the quantity of
carrier tape that remains on the reel. It will
fault if it becomes too low.
Integration
Pressing 4>INTEGRATION on the MODE
screen will bring up the screen shown in Fig-
ure 2.27.
Vision
The VISION option enables the TM-50 to con-
trol a vision inspection station to inspect parts
while the machine is in Run Mode. When the 1
key is pressed, the display will cycle through
three settings: OFF, 1, and 2.
Note:
Refer to the vision system user’s
guide which was provided with the vision
system for specific
Vision Mode
settings.
in the absence of a vision system manual,
refer to the
Vision Mode Timing
section
later in this chapter to determine the cor-
rect setting.
The vision inspection will occur at the end of a
tape advance. The system cannot inspect
components when the carrier tape is in
motion. Therefore, the ADVANCE setting must
be one pocket per move. Otherwise, the
machine will only inspect the last pocket at the
end of each tape advance.
Note:
The first part placed in tape must be
correctly oriented. The vision system is
programmed to initiate the job lot upon
detection of the first correct part.
Any empty pockets or incorrectly oriented
parts will be ignored until the first correctly
oriented part is inspected and the job
begins.
The vision inspection will always be active in
Run Mode when the VISION MODE setting is
1 or 2. Therefore, turn the vision system to the
OFF setting if it is not being used in Run
Mode. Otherwise, the operator will not, for
instance, be able to manually run a leader or
trailer in Run Mode with the vision system
enabled if the system is set to fail on empty
pockets.
Part Mark
The Part Mark feature functions the same as it
did in the standard software menu.
Auto Leader/Trailer
The Auto Leader feature functions the same
as it did in the standard software menu.
The additional features are now pro-
grammed. Press ESC until reaching the setup
1>VISION MODE OFF
2>PART MARK*
3>AUTO LdrTrlr*
-->
Figure 2.27
Summary of Contents for OEM TM-50 SMD
