54
D292469I
Once the tip is centered in the first pocket, press the
+
key to advance to the last
position of the waffle pack. The better these positions are aligned, the better
the die placement will be. For a more accurate calibration: start in single step;
pick a die; move it to place height; and then select
CALIBRATE TRAYS
.
NOTE
: You must calibrate all possible waffle packs, for example if you are using a
output fixture capable of attaching four waffle packs, but decide only to use two
packs, you still must calibrate all four waffle packs.
Clear All Trays
Selecting this will clear all trays and put them back to
Zero Loaded
. The operator
should do this when changing packs on the Output Fixture before they are
empty/full to insure the system starts back at pocket 1 for the new pack.
Pattern Number
Pressing
YES
with the curser
>
in front of
Pattern Number
will allow you to enter
the waffle pack part number.
A standard waffle pack will have a part number printed on one of its outside
edges. The part number will begin with
H20
for 2-inch waffle packs or
H44
for 4-
inch waffle packs. This portion of the part number will be ignored when entering
the number.
The display on the DE35 will default to
000000-00
. If the part number to be
entered is
H20-002
, it should be entered as
000002-00
on the display. If the part
number includes a second dash such as
H20-018-09
, it should be entered as
000018-09
on the display.
If the part number entered is a standard waffle pack, the DE35 will display the
word
CATALOG
to the right of the number and the machine will set the
approximate X/Y coordinates of the selected waffle pack. If the waffle pack is
not standard, the machine will briefly display
NEW PART #
and the word
CUSTOM
will be displayed to the right of the part number. The X and Y pitches
and the X and Y positions must be entered.
Die Per Tray
This item should not be manually entered. The number of die per tray will be
calculated automatically when the X and Y positions are entered. If you want to
put less die in the pack than a full pack will hold, you may manually enter the
smaller number after the waffle packs have been calibrated.
X Pitch
This number represents the distance in inches, from the leading edge of one
pocket to the leading edge of the next pocket in the X direction.
Summary of Contents for Royce DE35-ST
