4-22
TM-401 User’s Guide
Configure HMI Settings
D292104.7a.fm
10.
Set Place Position
a.
Use
the
Arrow
keys to position the
Pick Head
and
Carrier Tape
so the
Nozzle
is centered over the carrier tape placement position.
The
Up/Down Arrow
keys move the
Pick Head
forward and backward. The
Left/Right Arrow
keys move the tape left and right in the
Taper Track
.
b.
When the Nozzle is centered over the tape pocket, press
Set Place Position
to set the position.
c.
Press the right
Arrow Key
to move to the next
Job Wizard
screen.
11.
Set Place Nozzle Height
The
Pick Head
’s
Z Axis
(up/down) position needs to be
Step 6:
Setup HMI
NOZZLE
Summary of Contents for TM-401
