Appendix A: Sensors
A-2
Keyence FS-N11CP & FSN12CP Sensor Amplifiers
D291842.11.fm
Keyence FS-N11CP & FSN12CP Sensor Amplifiers
The
Keyence FS-N11CP
and
FS-N12CP
sensor amplifiers
(shown in Figure A.1 below) are used on the TM-400 Series
machines for the
Low Cover Tape Sensor
and the
Tape Jam
Sensor
. Both amplifiers are mounted on the
Cover Tape
Arm
. The
Low Cover Tape
amplifier (FS-N11CP) is located
on the left. The
Tape Jam
amplifier (FS-N12CP) is located
on the right.
The two amplifiers are designed to be attached electrically
and share power. Otherwise, the two units function indepen-
dently of one another.
Selecting the Output Mode
The FS-N11CP/FS-N12CP sensor-amplifiers can be set to two
Output
Modes
:
light-ON
or
dark-
ON
. This determines under what conditions the sensor is triggered and the
Operation Indicator
is
lit.
In
light-ON
mode, the sensor will be triggered when the current value (CV) of detected light from
the emitter is higher than the preset value (PV). In
dark-ON
mode, the sensor is triggered when
the CV of detected light is lower than the PV. Essentially, in
light-ON
Output Mode
the sensor
detects when an obstruction occurs (causing reflected light to increase) and in
dark-ON
Output
Mode
the sensor detects when an obstruction is removed (causing reflected light to decrease).
1.
Press the
Output Selector
button. The
CV Indicator
will display the current mode.
2.
Press the
Manual
button within 5 seconds of having pressed the
Output Selector
button.
The
Output Mode
will be toggled.
Figure A.1
Fiber Lock Lever
Set Button
Preset Value (PV) Indicator
Manual Button
Output Selector
Operation Indicator
Current Value (CV) indicator
Mode Button
Button
