3-2
TM-403 User’s Guide
Introduction
D292105.6a.fm
Introduction
This chapter gives an overview of the TM-402
Human Machine Interface (HMI)
, defining the but-
tons, screens and setting options that allow the operator to customize the TM-402’s performance
to their taping needs.
Note:
Proceed to
Chapter 4: Setup
for instructions on how to configure the HMI and to
Chapter 5: Operation
for instructions on how to run a job
Touch Screen
The user interacts with the TM-402 through a touch screen HMI which is located on the front of
the machine below the taper. Touching the HMI screen has the same effect as a left click with the
mouse. Although only lightly touching the buttons or data fields is necessary for activation, the
action is referred to as “pressing” in this manual.
Note
: Use care when operating the touch screen and do not use any objects other than a
finger to touch the screen. A stylus can also be used to click the various buttons.
HMI Tabs
When the TM-402 is powered on, the user interface opens to the
Job Tab.
The
Job Tab
is pic-
tured above as it appears when the motors have been homed.
The
Tab Menu
is located on the left side of all screens. There are five tabs on the TM-402 HMI:
Job, Taper, Head, Bowl
and
Run
. These tabs allow the user to configure pick head, taper, bowl
feeder and job settings and to run jobs.
To navigate between tabs, press the desired tab name on the Tab Menu and the selected tab will
open. The active tab button is shaded blue. In the example on the above, the
Job Tab
is
selected.
