D292105.7b.fm
Configure HMI Settings
Chapter 4: Setup
4- 21
keys move the
Pick Head
forward and backward. The
Left/Right Arrow
keys
move the tape left and right in the
Taper Track
.
b.
When the Nozzle is centered over the tape pocket, press
Set Place Position
to set the position.
c.
Press the right
Arrow Key
to move to the next
Job Wizard
screen.
11.
Set Place Nozzle Height
The
Pick Head
’s
Z Axis
(up/down) position needs to be
set at the
Place
position.
a.
To manually set the
Place
Actuator
to
the correct nozzle height,
press
Place
Extend
b.
Use a 2.5mm hex wrench to hold the
Actuator Adjustment Screw
in place
from the bottom, while loosening the
Jam Nut
on top of the
Actuator
Adjustment Screw
with
an 8mm open
ended wrench
.
Lower the
Nozzle
until
the part is barely touching the top of
the pocket in the
Place Location
.
c.
Tighten the
Jam Nut
.
d.
Press
Place Retract
to retract the
Nozzle to a safe height.
e.
Press the right
Arrow Key
to move to
the next
Job Wizard
screen.
Step 6:
Setup HMI
PICK
HEAD
