RAPID-VSC-DEM
Instructions - user maintenance manual
-
©02/20 Rev:1.0
/TRANSLATION OF THE ORIGINAL
INSTRUCTIONS
Page 9
1.2.1
UK
M
ARKET
C
OMPLIANCE
The machine complies with current UK legislation.
By affixing the UKCA mark, you assume full responsibility for the product's compliance with the requirements of the relevant
legislation.
The UKCA mark is only used to demonstrate that the product complies with UK legislation.
The UKCA mark is only affixed to the product by the manufacturer or authorised representative (where permitted by
legislation); on the machine covered by this instruction manual it is affixed directly by V-TUF, which ensures conformity.
By the act entitled The Product Safety and Metrology etc.. (Amendment etc.) (EU Exit) Regulations 2019 No. 696, which
entered into force on 1 January 2021, a number of changes have been introduced with a general impact on all product
safety legislation. Including, of course, machine regulation.
In particular, in Regulations 2019 Act No. 696 the Uk Declaration of Conformity is defined, the Ukca mark is inserted in
place of the CE mark, as is the replacement of the Low Voltage Directive by The Electrical Equipment (Safety) Regulations
2016 No. 1101. In addition, all references to EU legislation have been removed and the definitions amended to make them
specific to the movement of products in the UK. This manual is translated into English for export to the UK.
As of 1 January 2021, the rules for importation into the UK by economic operators are the same, except for the drafting of
the UK Declaration of Conformity and the drafting of the manual and technical file in English.
1.3 C
OMPLIANCE WITH LEGISLATION
In addition to the rules of this Manual, the specific legal provisions in the field of accident prevention at work must be
observed.
1.4 D
ECLARATION OF ABSENCE OF HARMFUL SUBSTANCES
We hereby declare that our products, including hot-melt adhesive used during processing the machine, are produced with
materials that comply with the limits established by the regulations in force on the protection of health and the environment
and do not contain substances classified as SVHC (Substance of Very High Concern) in accordance with EC 1907/2006
regulation (REACH, i.e.
Registration, Evaluation, Authorisation and Restriction of Chemical substances).
Although the above mentioned substances are not employed in processing cycles of raw materials and our products, their
presence cannot however be ruled out in the order of ppm (parts per million), due to the micro-pollution of the raw materials.
1.5 P
URPOSE OF THE DOCUMENT
The purpose of this manual is to provide the user with the indications and information to be followed scrupulously for the
correct use of the machine and for the protection and safety of the operator called upon to interact with it.
For this reason, the User is invited to:
-
make this document available in the workplace and explain it to all operators,
-
passing on the manual to subsequent owners of the machine.
1.6 M
ARKING DATA AND MACHINE IDENTIFICATION PLATE
(MACHINE
DETAILS)
The nameplate on the machine shows the manufacturer's data, the model, the serial number and the year of construction.
For any communication regarding the machine (problems encountered, warranty work, spare parts, etc.) always refer to
this and the data contained therein.
In addition, any warning signs attached to the machine must not be removed for any reason whatsoever and must be strictly
observed.