RAPID-VSC-DEM
Instructions - user maintenance manual
-
©02/20 Rev:1.0
/TRANSLATION OF THE ORIGINAL
INSTRUCTIONS
Page 28
10.2 W
ATER CONNECTION
On the front of the machine there is a water inlet connection.
Connect a water supply hose (not supplied) to the inlet fitting (1 in the figure) and the other end of the hose to the tap (2),
which must guarantee a minimum flow rate equal to that of the pump
T
HE HYDRAULIC CIRCUIT DIAGRAM IS ATTACHED TO THE DOCUMENTATION SUPPLIED WITH THE MACHINE
.
WATER CONNECTION PICTURE
A
TTENTION
All work on the connection of the machine to external energy sources must be carried out by qualified
personnel, in compliance with current regulations and under the supervision of the manufacturer's
technicians.
Pneumatic hoses sized for the same or higher pressures should be used for connection.
Use only clean water as a high-pressure medium. Impurities cause premature wear or scaling in the unit
1
