RAPID-VSC-DEM
Instructions - user maintenance manual
-
©02/20 Rev:1.0
/TRANSLATION OF THE ORIGINAL
INSTRUCTIONS
Page 31
CHAPTER 12 - P
REPARING THE MACHINE FOR USE
After positioning the machine in the work area and making the connections to external energy sources (see
ONNECTIONS TO EXTERNAL ENERGY SOURCES
"
), it is necessary, before carrying out the work cycle, to check the operation
of all the protection devices on the machine and carry out the daily checks.
Now connect the wand to the A.P. (high pressure) hose (see drawing 1 below) (A) and the other end of the hose to the
outlet fitting (2 - picture opposite).
Fit the sheath (B) to protect the hydraulic connection and avoid contact burns.
The A.P. (high pressure) pump is supplied already filled with lubricating oil.
IGNITION
1. Battery not included
2. This unit cannot be sold, transported or shipped complete with battery for safety
reasons.
3. A 44 Amp/h 12V DC battery can be purchased from a local authorised dealer.
ATTENTION
The adjustment operations described in this chapter must be carried out
ONLY
by qualified and authorised
personnel.
Use protective devices during maintenance, replacement and adjustment operations.
Before starting work, always check that no hazardous conditions exist in the working area.
NEVER LEAVE THE PRESSURE WASHER WITH THE ENGINE RUNNING.
W
ARNING
NEVER START
the pump dry as this could cause damage to the pump. If the pump does not suck in
water, switch off the engine immediately.
