RAPID-VSC-DEM
Instructions - user maintenance manual
-
©02/20 Rev:1.0
/TRANSLATION OF THE ORIGINAL
INSTRUCTIONS
Page 37
CHAPTER 14 - M
AINTENANCE
Maintenance is a set of periodic and predefined operations aimed at maintaining the functionality of the machine in all its
aspects, as a result of the wear and tear inherent in its use.
The various routine maintenance operations are described below. Please note that lower operating costs and a long service
life of the machine depend on continuous compliance with this manual.
For extraordinary maintenance operations not covered in this manual, contact the manufacturer.
CAUTION: all the operations described in the following paragraphs must be carried out with the machine switched
off and the electrical system disconnected.
14.1 P
RESSURE WASHER CLEANING
Wash with neutral products and water only, then dry thoroughly to remove any water pockets.
Plastic parts should be cleaned in a normal washing procedure.
If there are still traces of dirt, we recommend the use of specific products, carefully observing the manufacturer's
instructions.
Do not use products containing solvents, methanol or hydrocarbons.
14.2
MAINTENANCE INTERVALS
DAILY: Check the high-pressure hose for damage (burst hazard).
WEEKLY:
Check oil level. In the event of milky oil (water in the oil), contact Customer Services immediately.
MONTHLY:
Clean the water filter; Clean the filter on the detergent suction hose Check for cracks in the fasteners
between the engine and the frame, ask the customer service department to replace the cracked fasteners.
AFTER 500 HOURS or
ONCE A YEAR: Have the appliance serviced by the service department
14.3 P
UMP LUBRICATION
Change the oil after the first 50 hours of operation and every 500 hours thereafter. The recommended oils are shown in the
table below.
POINT TO SUPPLY
QUANTITY
RECOMMENDED
PRODUCT
-20°C +40°C
PUMP (mod. 20
– 21)
1.2 l
V-TUF PL500 Pressure Lube
PUMP (mod. 11
– 15)
0.42 kg
V-TUF PL500 Pressure Lube
