2
Using for the first time
2.1
Note
The appliance can only be operated
after standing in the normal operating posi-
tion for about 2 hours
.
The appliance must be installed and connected to the electricity supply in accordance
with the separate installation instructions. Have a qualified fitter/electrician carry out the
necessary work.
2.2
Function description
When the appliance is connected to the power supply for the first time, it is possible to
select a function test. The purpose of the function test is to check the installation. It takes
about 3 minutes. The function test can be selected immediately after installation. The
heat pump is not started during the function test. Before the definitive initial start-up of
the appliance, it must stand in the normal operating position for around 2 hours, other-
wise the heat pump could become damaged.
The function test cannot be aborted by interrupting the power supply.
Once the function test has been run or aborted, it can no longer be selected and
the appliance enters the normal selection mode.
2.3
Starting the function test
▸ Connect the appliance to the mains.
–
In the display appears:
–
The indicator lights for the programme buttons
and
flash.
Pause function test
ende
continue
▸ Press the
button.
–
The function test starts.
–
The duration remaining of the function test appears
in the display.
Function test
0h03
2.4
Ending the function test
Once the function test is completed, in the
display appears:
Pause function test
ende
continue
The display goes out automatically after
30 minutes or after taking the following ac-
tions:
▸ Open the appliance door.
or
▸ Touch the
button.
The appliance can only be operated after standing in the
normal operating position
for around 2 hours.
7
