8 Trouble-shooting
... in the display appears
U1 / E42 See instructions
FN XXXXX XXXXXX
Possible cause
Solution
▪
Overvoltage.
▸ Acknowledge the error message by touching the
button.
▸ Turn the power supply off for about 1 minute and then
turn it back on again.
▸ Next select a programme.
If the error appears again:
▸ Disconnect the power supply.
▸ Have an electrician check the house installation.
If the error appears again:
▸ Note down the message in full and the manufacturer’s
or serial number (FN or SN).
▸ Disconnect the power supply.
▸ Call Customer Services.
▸ Inform the caretaker, the owner of the appliance or the
property management company.
... in the display appears «Final airing»
Possible cause
Solution
▪
The laundry is being
cooled down.
▸ No action is necessary. The laundry can be unloaded
at any time as long as it is then spread out to cool
down.
▪
A high ambient temper-
ature extends the cool-
ing-down phase.
▸ No action is necessary. The laundry can be unloaded
at any time as long as it is then spread out to cool
down.
▪
The temperature sensor
is dirty.
▸ Clean the temperature sensor (see page 28).
... it is not possible to select a new programme after closing the appliance door
Possible cause
Solution
▪
A programme was inter-
rupted.
▸ Touch the
button.
▸ Select a new programme.
... the appliance does not start
Possible cause
Solution
▪
The appliance door is
open.
▸ Close the appliance door.
▪
Interruption in power
supply.
▸ Insert plug into mains socket.
▸ Turn wall switch on.
▸ Check the fuse or circuit breaker.
33
