Installation instructions
Washing machine
One-family household
1014123-R03
31/10/2017
1014123-R03
5
5. Levelling
To ensure fault-free operation, the appliance must stand level with all 4 feet firmly on the installation plate and not
wobble.
S
W
▸
Roughly adjust the height of the front and rear adjuster feet us-
ing wrench
S
(socket wrench 10). Height adjustment: ≤14 mm
(1.5 mm per turn)
▸
Use a spirit level
W
to level the appliance.
▸
Slide the appliance onto the installation plate.
▸
Finely adjust the height of the front adjuster feet using wrench
S
.
▸
Use a spirit level
W
to level the appliance.
–
The appliance must not wobble!
6. Plumbing in
Local water authority regulations must be observed.
Any old water supply and drain hoses must always be replaced with new hoses.
Water inlet
Preferred alignment for Aquastop valve block
1
(sound-optimized installation):
1
▸
Tap seal seat must be clean and flat.
▸
Install hose without kinking or twisting it.
▸
Check for leaks.
▪
Cold water only G¾ inch.
▪
Possible pressure range: 0.1–1.0 MPa (1–10 bar).
▪
The appliance must not be connected to a mixer tap
or a continuous flow boiler!
Water outlet
Hose clamp
Drain hose
Rubber connector
Shorten drainage hose
to required length.
Cannot shorten
drainage hose!
ø exterior 28.0
ø interior 21.5
1500
Hose support (bend)
≤1200
≤700
≥350
▸
When installing the drain hose, prevent it from becoming damaged or buckling (hot suds discharge).
▸
For all connection types, mount the hose support.
▸
If draining into the bath, sink, etc., use the hose support to fix the end of the hose.
▸
Pumping height of drain pump with open outlet: ≤1.2 m.
