4 Care and maintenance
4.2
Metal grease filters
The metal grease filters should be cleaned at least every two months with normal use
(more frequently with intensive use) and whenever the saturation indicator alarm is
triggered. If properly cared for, the grease filters should provide years of service.
Removing
2
1
▸ Fold down the metal grease filters
at the front and carefully remove from the slots
in the fixture.
Cleaning
▸ Clean the metal grease filters in the dishwasher. Select the «intensive» dishwasher
programme. If no dishwasher is available: Soak the grease filters in hot water and mild
detergent.
▸ Clean, rinse well with clean cold water and then wipe dry.
–
Grease filters can be used again after being cleaned.
▸ Put the metal grease filters back.
▸ Reset saturation indicator alarm (see page 14).
Cleaning may cause the metal grease filters to become slightly discoloured. How-
ever, this will not affect the functioning of the filters in any way.
4.3
Reset saturation indicator alarm
Reset the saturation indicator alarm for both the metal grease filter
and the activated
charcoal filter
after cleaning/replacing.
▸ With the appliance switched off, hold the
button depressed for 5 seconds.
–
If reset correctly, the
and
symbols are no longer displayed.
4.4
Replacing the LED light bulbs
For safety reasons, the LED light bulbs must be replaced by our Customer Services.
14
Summary of Contents for AiroClearWall V4000
Page 1: ...Operating instructions AiroClearWall V4000 Range hood ...
Page 20: ...20 10 Notes ...
Page 21: ...21 ...
Page 22: ...22 ...