8 Care and maintenance
Fitting the door seal
The joint and vent hole
X
must be at the left in the middle.
▸ Fit the seal starting in one of the corners at the
top.
▸ Insert the clip from the outside to the inside at
a 30° angle into the slot. Once the seal is fitted
at the top, insert the bottom two clips.
▸ Press the door seal into the groove all around,
i.e. at the top, bottom, left and right.
1.
2.
3.
4.
X
8.8
Replacing the door seal (in pyrolytic appliances)
We generally recommend the door seal be replaced by our service staff. However, you
can also replace the door seal of your appliance yourself.
We accept no liability for any damage caused by the door seal not having been fitted
properly.
Removing the door seal
▸ In each of the four corners, turn the seal out-
wards by about 30° and carefully pull the clip
out of the slot.
▸ When all four clips have been released, re-
move the seal.
▸ Clean the groove in the appliance with a damp
cloth.
1.
2.
3.
4.
X
Fitting the door seal
The joint
X
must be at the bottom in the middle.
▸ Fit the seal starting in one of the corners at the
top.
▸ Insert the clip so that it hooks into the outer
slot.
▸ Once the seal is fitted at the top, insert the bot-
tom two clips.
▸ Lightly press the seal into the groove all
around, i.e. along the top, bottom, left and
right.
1.
2.
3.
4.
X
Checking the seal is seated properly
All four clips must be hooked in.
▸ If not, remove the seal and put the corner hooks in again.
▸ Lightly press the seal into the groove all around, i.e. along the top, bottom, left and
right.
55
Summary of Contents for Combair V6000 45
Page 66: ...66 15 Notes...
