11 Care and maintenance
▸ Ensure that only the thinner part
4
of the seal is
pressed into the groove; the thicker part
5
must
not be in the groove.
4
5
▸ Starting from the bottom, press the seal evenly into
the groove.
11.7
Replacing the halogen light bulb
WARNING: Risk of electric shock!
Disconnect the appliance from the mains power supply before replacing the halo-
gen light bulb.
Risk of burns from hot surfaces!
Allow the halogen light bulb and the appliance to cool down before replacing the
halogen light bulb.
▸ Remove the left shelf guide.
▸ Place the screw driver along the middle of the
edge of the glass and carefully remove the glass
light cover
1
from its fixture.
▸ Take out the defective halogen light bulb.
▸ Carefully fit the new halogen light bulb.
1
Do not touch the halogen light bulb with bare hands. Instead, use a fine, dry,
grease-free cloth.
▸ Press the glass light cover
1
back into its fixture.
▸ Replace the shelf guides.
▸ Switch the power supply back on.
11.8
Cleaning the accessories and shelf guides
Incorrect handling can cause damage!
Do not clean the food probe in the dishwasher.
▪
The wire shelf and shelf guides can be cleaned in the dishwasher.
▪
The baking tray can be cleaned in the dishwasher; however, this will affect its non-
stick properties.
▸ Clean the food probe with a soft cloth dampened with water and a little washing-up li-
quid.
39
