Installation instructions
CombiCooler/Cooler/WineCooler/Freezer
V6000 Supreme, integrated
1091916-R01
07/05/2020
1091916-R01
8
Fitting the door panels
Preparing the door panels for the door and drawer
The dimensions of the door panel are shown in the table and in the diagrams below. However, the upper refrigerator door panel may be
higher than the top edge of the door itself and the lower door panel may be lower than the bottom edge of the drawer in order that the
appliance is aligned with the rest of the kitchen cabinets. The door panels are fitted by means of special brackets, which must be
already mounted, and hooked on the adjusting screws, which must be similarly already mounted on the refrigerator doors. The door
panel is fixed vertically by mounting brackets and can be adjusted where necessary. Brackets, mounting brackets and corresponding
mounting screws are included in the scope of delivery of the appliance and are fastened to the door panel following the drilling dia-
grams below and with the aid of the drilling template supplied.
Procedure for fastening the brackets to the door panels.
The mounting brackets must be fitted before the handle.
▸
Draw a line vertically down the middle of the door
panel, thus dividing it into two equal halves.
▸
Starting at the bottom of the door panel, mark the
height at which the holes need to be drilled.
▸
Based on the details in the table for the relevant
model, first mark the outer holes and then the inner
holes.
▸
Make sure the holes are marked in the right place by
placing the brackets and mounting brackets on the
marked points.
▸
Carefully drill the holes, keeping in mind the thickness
of the panel.
▸
Securely fix the brackets and mounting brackets.
