FRANÇAIS
- 77 -
La partie N°2
indique le nombre de centaine de cycles restant
avant la prochaine demande d’entretien: la valeur est arrondi à la
centaine.
La partie N°3
représente l’établissement de ce dernier compteurs:
à la première pression de la touche
h
ou
i
, la valeur en cours
du compteur est arrondi aux mille, chaque pression successive
augmente le réglage de 1000 unités ou le diminue de 100.
Le comptage précédemment visualisé est perdu.
11.1 - SIGNALISATION DE LA NÉCESSITÉ
D’ENTRETIEN
Quand le compteur des cycles restant avant entretien arrive à
Zéro, l’armoire le signale à l’utilisateur en effectuant un préavis
supplémentaire de 5 secondes avant chaque démarrage du
portail.
La signalisation est répétée avant chaque départ en ouverture
jusqu’à ce que l’installateur accède au menu
SErv
.
Si celui-ci ne programme pas un nouveau nombre de cycle, la
fonction est désactivée et la signalisation n’interviendra plus.
m
ATTENTION: les opérations d’entretien doivent être
réalisées uniquement par du personnel qualifié.
11 - LECTURE DU COMPTEURS DE CYCLES
L’armoire KB1 mémorise le nombre de cycles effectués par
l’automatisme et peut également signaler la nécessité d’effectuer
un entretien après un certain nombre de manoeuvres.
Il y a a disposition deux compteurs:
• Compteur du nombre de cycles totals réalisés (option
tot
du
menu
Cont
)
• Compteur dégressif des cycles restants avant la prochaine
demande d’entretien (option
SErv
du menu
Cont
).
• Compteur des évènements (option
EvEn
, voir le chapitre 12)
Pour accéder au menu, suivre les indications suivantes:
1.
Maintenir enfoncée la touche MENU jusqu’à quand l’afficheur
visualise
-Cnt
2.
Relâcher la touche MENU: l’afficheur visualise
tot
Le schéma suivant montre la procédure pour lire le compteur de
cycles et pour lire et/ou programmer le nombre de cycles restant
avant la prochaine demande d’entretien (dans l’exemple l’armoire
a effectué 12451 cycles et il reste 1300 cycles avant la prochaine
demande d’entretien).
La partie N°1
indique le nombre de cycles effectués: avec les
touches
h
et
i
on alterne entre la visualisation des milliers et des
unités.
3
2
-Cnt
tot
SEru
EvEn
ESC
-01.3
-02.0
-01.0
-03.0
1
0 12.
.45 1
Summary of Contents for AYROS
