ENGLISH
- 51 -
PARAMETER
VALUE
DESCRIPTION
AntE SCor
MEMO
r.Ch
Closing door delay
3.0” 0.0”
0.0” - 1’00
During the closing phase, leaf 1 must start moving after leaf 2, to
avoid that both doors may collide.
Leaf 1 closing will be delayed for the setup time
C2rA
Closing leaf 2 during delayed opening
With some gates, the second leaf is held closed by a pole, which
might become blocked if the leaf is left free while leaf 1 only is
opened.
This parameter makes it possible to exercise slight closing pressure on
leaf 2 during delayed opening, so that the pole remains free.
no
no
no
Function deactivated
Si
Function activated
t.SEr
Lock time
2.0”
no
0.5”- 1’00
Before the opening phase begins, the control unit will energize the
electric lock in order to release it and enable the gate motion.
t.SEr
time will fix the energizing time.
m
WARNING: in case the gate has no electric lock, set the
value
no
no
Function deactivated
SEr.S
Silent Locking Mode
Si
Si
Si
Function activated (140 Hz)
no
Function deactivated (50 Hz)
t.ASE
Lock advance time
1.0”
0.0”
0.0”- 1’00
While the electric lock is energized, the gate will stay standstill for
t.ASE
time, to make its release easier.
In case
t.ASE
is lower than
t.SEr
, the lock energizing will go on
while the doors will start moving.
m
WARNING:
in case the gate has no electric lock, set the value
0.0”
t.inv
Backlash time
no
no
no
Function deactivated
0.5” - 1’00
To facilitate uncoupling of the electrical lock, it may be useful to
control the motors before starting opening for a short time.
The control unit controls the motors in reduced power in closing
direction for the setup time
t.PrE
Pre-blinking time
1.0”
1.0”
0.5” - 1’00
Before any gate movement, blinker will be activated for
t.PrE
time,
to warn about the incoming motion
no
Function deactivated
t.PCh
Different closing pre-flashing time
no
no
no
The closing pre-flashing time corresponds to
t.PrE
0.5” - 1’00
If this parameter has a value assigned to it, the control unit will
activate pre-flashing prior to closure for the length of time set in this
menu
