V2 LEX-HRM, Manual

ENGLISH

- 19 -

ADVANCED PROGRAMMING 

To perform ADVANCED programming it is necessary to remove 
the cover plate of the remote control and carefully follow the 
dedicated procedures for the various functions.

Each function can be selected by entering a code during the 
programming procedure; following is a summary table of the 
functions with their relative programming codes.

A: 

Code to activate programming

B:

  Indicates channel 1 of the remote control; for channel 2 the 

number is 12, for channel 3 the number is 13, etc. up to 
channel 6

C:

  Code of the function to be programmed

The pictures that follow include references to the buttons and the 
LEDs used during programming.

CODE

FUNCTION

A

B

C

12 11 11 Storage of the transmitters 
12 11 13 Deletion of all the stored transmitters
12 11 17 Storing of the level of intervention of the wind 

sensor

12 11 18 Programming of the level of intervention of the 

sun sensor

12 11 21 Programming of the level of temperature

L1

L2

L3

L4

L5

L6

UP

STOP

DOWN

PROG

TRANSMITTERS OF THE RANGE 
ADLER

Using a transmitter of the range ADLER it is possible changing the 
functions of the control unit controlling the tubular motor.

QUICK STORAGE OF THE TRANSMITTER

m

CAUTION

: the first transmitter recorded determines the 

direction of the motor’s movement.

m

CAUTION

: If the sunshade has a casing, record the first 

remote control by following the procedure “1. Record the 
transmitters and select the sunshade mode”

To record remote controls for a new control unit that drives 
a shutter or a sunshade (NOT with casing) proceed as 
follows:
1.

  Power only the control unit to be programmed

2.

  Press and hold down UP and DOWN until the motor starts to 

move in a direction

3.

  Release the buttons: the motor will stop

4.

  Press UP or DOWN following the direction the roll-up shutter 

moved prior to stopping: 

-    if the roll-up shutter was rising, press UP; direction 

acquired: the UP button raises the roll-up shutter, the 
DOWN button lowers the roll-up shutter

-    if the roll-up shutter was lowering, press DOWN; direction 

acquired: the DOWN button lowers the roll-up shutter, the 
UP button raises the roll-up shutter

5.

  End of programming

To add other remote controls, proceed as follows:
6.

  Press and hold down the UP and DOWN buttons of a remote 

control that is already recorded until the motor starts to move 
in a direction

7.

  Release the buttons: the motor will stop

8.

  Press the UP or DOWN button on the new remote control